I am not a PLC programmer, but I was interested in programming PLC. I had Fatek PLC programmer software, so I was looking for simulating code before burning it on PLC. Actually, there are no tutorials over internet on how to make simulation in this software. Therefore, in this post I will show how to make a simulation, just follow the few steps below:
- Open WinProLadder software of Fatek PLC and create a new file.
- Write your ladder diagram
- Go to menu bar -> PLC -> Simulation and click it.
- When simulation is active, press the button "Run PLC"
- Now, you will be able to simulate the PLC and you can interactively configure the status of contacts and relays.
- Open WinProLadder software of Fatek PLC and create a new file.
- Write your ladder diagram
- Go to menu bar -> PLC -> Simulation and click it.
- When simulation is active, press the button "Run PLC"
- Now, you will be able to simulate the PLC and you can interactively configure the status of contacts and relays.
simulator option is hide mean we cant click on it so please tell me what to do
ReplyDelete